This program will not eliminate all servicing issues related to your gates and gate operator equipment, however, we do expect to decrease the volume of problems significantly. This will be accomplished through 4 pre-scheduled inspections, proper lubrication and adjustments as detailed below:
- Thorough inspection of all equipment
- Lubrication of all points of friction (hinges, bearings)
- Test charging system & batteries for proper voltages
- Test battery backup system (if applicable) for proper function
- Check fluid levels in gearbox & top off if necessary
- Adjust open/close limits if necessary
- Test all photo eyes for proper function, clean lenses, & reflectors
- Inspect/test all functions of all vehicle loops
- Test probe (if applicable) for proper function
- Test emergency entry equipment for proper function
- Tighten any loose fasteners
- Trim any shrubs that are interfering with gate operation
- Clean operators & apply pesticide
- Clean telephone entry/keypad
- Check all bulbs on keypad/telephone entry system
- Tighten drive chain (if applicable) & lubricate
- Verify all set screws are tight on sprockets
- Verify all keys are in keyways
- Test manual override for proper operation
- Inspect gate for any broken welds or damage
- Place service labels on operators
- Detailed list of any repairs recommended by our service technician
Should a part require replacement during routine maintenance, we will promptly inform you of the specific component in need of replacement, along with the associated cost.
The cost of the plan is based on the type of gate and the model of the gate operator.
Disclaimer:
The maintenance plan does not cover the following:
- Vandalism to the gate or gate operator
- Damage caused by vehicles
- Damage resulting from natural events
